Inhaltsverzeichnis
Werbung
2.3
Assembly
Before assembly, take a close look at the individual assembly steps shown and carry out the
assembly in the order given.
NOTICE
L
First loosely screw all parts together and check that they fit properly. Tighten the screws using
the tool only when you are instructed to do so.
Step 1:
Assembly of the side planks
1.
Place a joint connector bolt (A) and two positioning pins (B) into the slots of the lower side
planks (3 & 4).
2.
Align the upper side planks (1 & 2) with the joint connector bolts (A) and the positioning pins
(B) and connect the upper side planks (1 & 2) with the lower side planks (3 & 4).
3.
Tighten the nuts on the joint connector bolts (A) with the wrench (L) and place the caps (C)
on the slots on the side planks.
32
WALLBAR
Werbung
Inhaltsverzeichnis
Fehlerbehebung
