Product Description - Concept VP 4310 Bedienungsanleitung

EN
• Never use the vacuum cleaner without filters. Before each use, make sure that the filters of the vacuum
cleaner are installed properly.
• Do not immerse the power cord, charging adaptor, or appliance into water or any other liquid.
• Check the appliance and the charging adaptor power cord for damage regularly. Do not switch on
a damaged unit.
• Turn the unit off, and let it cool down before cleaning and after use.
• Prior to vacuuming, it is necessary to remove large or sharp objects that could damage the dust filter from
the surface to be cleaned.
• Do not use the product if the filters are fouled.
• Do not throw the accumulator in fire, and do not expose it to temperatures higher than 40 °C.
• Do not touch the moving driven parts of the unit during operation.
• Do not repair the appliance yourself. Contact an authorized service center. This appliance may be used by
children 8 years of age and older and by persons with physical or mental impairments or by inexperienced
persons if they are properly supervised or have been informed about how to use of the product in a safe
manner and understand the potential dangers. Children must not play with the appliance. This appliance
may be cleaned by children 8 years of age and older if they are properly supervised. Keep this appliance
and the power cord out of reach of children younger than 8 years of age.
Failure to follow the manufacturer's instructions may lead to refusal of warranty repair.

PRODUCT DESCRIPTION

1 Dust receptacle
2 Charging indicator light
3 Switch
4 Body of the unit
Accessories
A Charging base
B Charging adaptor
34
1
3 2
4
A B
OPERATING INSTRUCTIONS
Assembling the vacuum cleaner
NOTE
Always turn off the unit and disconnect the plug from the mains outlet prior to mounting or removing
accessories!
Charging the accumulator
Before the first use, or after the accumulator is depleted, let the unit charge for about 6,5 hours.
To charge the accumulator, place switched off unit in the charging base, connect the power cord, and
connect the adaptor to wall outlet.
If you want to preserve the accumulator's service life, charge it only after it is depleted.
The service life is about 150–200 charging cycles.
Note: Charging indicator glows red if the unit is in the charging base and the connected adaptor is
connected to a wall outlet.
The time of operation of the unit after the accumulator is fully charged is about 8 minutes.
Position of the charging base.
• You can fix the charging base to a wall, or leave it standing.
• Insert the charging adaptor power cord into the hole in the charging base, and fix it by turning it by 90°.
Using the vacuum cleaner
1. Take the unit out of the charging base.
2. Turn the unit on using the switch.
3. Release the switch after use, and the unit will turn off.
Checking the dust receptacle content level
If the suction power is decreased, or the dust receptacle is full, empty it and clean the filter
MAINTENANCE
As a preventive measure, we recommend emptying the dust receptacle and cleaning the filter of the vacuum
cleaner after each use.
Emptying the dust receptacle
1. Disconnect the charging adaptor from the wall outlet.
2. Hold the unit with the dust receptacle pointing downwards.
3. Release the dust container by twisting.
4. Empty the dust receptacle.
5. Follow the reverse procedure to put back the filter, and install the dust receptacle.
VP 4310 VP 4310
EN
35