Connections - Omnitronic DD-5220L Bedienungsanleitung

6. CONNECTIONS

Prior to connecting or changing existing connections switch off the turntable.
1
Connect the analog audio output of the turntable with the supplied RCA cable to the corresponding
input jacks at the amplifier or mixer. Make sure that the right/left occupation (plug color red/white) is the
same at both units.
• When connecting to input jacks for a turntable set the sliding switch [PHONO/LINE] to position
[PHONO].
• When connecting to input jacks for units with line level set the sliding switch [PHONO/LINE] to position
[LINE].
2
Connect the supplied power supply cable to the corresponding input and the mains plug to a socket
(230 V AC, 50 Hz ~).
If the device will be directly connected with the local power supply network, a disconnection switch with a
minimum opening of 3 mm at every pole has to be included in the permanent electrical installation. The device
must only be connected with an electric installation carried out in compliance with the IEC-standards. The
electric installation must be equipped with a Residual Current Device (RCD) with a maximum fault current of
30 mA.
23/27 00063727.DOC, Version 1.0