Omnitronic DD-5220L Bedienungsanleitung Seite 22

Adjusting the anti-skating facility
Fig. 8: Adjusting anti-skating
When playing a record, forces occur on the stylus
which are compensated by the anti-skating facility.
For this purpose, adjust the anti-skating knob from
[0] to the value which equals the stylus pressure.
The value is indicated on the knob (Fig. 8).
Adjusting the height of the tone arm
support
The tone arm height varies depending on the
phono cartridge system and the underlayer placed
on the turntable platter. To ensure perfect pick-up
the height of the tone arm support can be
matched in six steps.
Fig. 9 Unlocking the adjustment ring
1
Turn the locking lever counterclockwise (Fig. 9).
Fig. 10: Adjusting the height
2
By means of the adjustment ring lift the tone
arm support within the range by up to 6 mm;
the default setting is 0 mm (Fig. 10). Make
your adjustment according to the following
table:
Height of cartridge
system in mm
15
16
17
18
19
20
21
3
Subsequently, fix the height of the tone arm
support by turning the locking level
Mounting the target light
Fig. 11 Connecting the target light
Take the target light out of one of the two lateral
polystyrene wrappings and plug it into the
corresponding RCA jack (Fig. 11). The target light
activates automatically when switching on the
power. Adjust the light freely in a range of 360°.

Caution!
Never connect any other plugs, e.g. mixer inputs
etc. to this jack! Otherwise, danger of heavy
equipment damage.
22/27
Adjusting ring
0
1
2
3
4
5
6
00063727.DOC, Version 1.0