Cleaning And Maintenance - Concept TM 4740 Bedienungsanleitung

EN
EN
on the bottom of the bowl. You may increase the motor rotation speed to the maxi-
movements on the bottom of the bowl. You may increase the motor rotation speed to the
mum for a short time using the Turbo button.
maximum for a short time using the Turbo button.
6. Switch the unit off after mixing. Disconnect the cable from the socket.
7. Press the buttons on the sides of the appliance to release the extension (Fig. 2) and wash
7. Push the extension release buttons (Fig. 1) to release the stick extension from the body
it under running lukewarm water immediately. Make sure the water does not get inside
and wash it under running lukewarm water immediately. Make sure the water does not get
inside the extension to the driving shaft area. If this happens, leave the stick extension to the extension to the driving shaft area. If this happens, leave the stick extension to dry,
and apply a few drops of vegetable oil to ease the operation of the stick bearings.
dry, and apply a few drops of vegetable oil to ease the operation of the stick bearings.
EXAMPLE  MAYONNAISE RECIPE
200 – 250 ml oil
1 whole egg
1 teaspoon lemon juice or vinegar
salt and pepper
Put all the ingredients in the mixing bowl in the above-mentioned order. Insert the stick
extension to the bottom of the mixing bowl. Switch ON, and hold the unit in this position until the oil creates an
emulsion. Move the operating unit up and down slowly, until the mayonnaise has the required density.

CLEANING AND MAINTENANCE

Switch the unit off and pull the plug from the socket prior to cleaning and after use of the unit.
Clean the unit body with a wet cloth.
Do not use steel wool, abrasive agents or solvents to clean the unit.
The transmissions must not be exposed to water! Wipe them with a damp cloth only.
Do not immerse the stick extension in water! Just rinse it. Make sure the water does not enter the extension where
the driving spindle is. If this happens, leave the stick extension to dry and apply a few drops of vegetable oil to ease
the operation of the extension bearings.
Wash the vessels and blades in tepid water with detergent and rinse in clean water; you can use a dishwasher.
Some of the plastic parts may change colour when you process ingredients with a higher pigmentation level (e.g.
carrots). To remove the colour, apply vegetable oil to these parts and let it work for a couple of minutes before
washing.
The warranty conditions do not apply to defects caused by improper or inadequate maintenance of the
equipment.
TM 4740
Fig. 2
19