Environmental Protection; Cleaning And Maintenance - Concept SM 3410 Bedienungsanleitung

EN
"Crusher" ON – Crusher function
Blender under this mode will automatically work: few seconds on and stop, and repeat processing for several
time. Ice crushed under this mode will not spray and stick onto the glass jar wall
"Smooth blending" ON – Crusher function
Blender under this mode will automatically work: speed moves faster and faster till to max speed.
"Stepless Speed"
If you want the blender moving slowly, turn the adjustment from "Min".
If you need the blender moving fast, turn the adjustment till to "Max".
OPERATING INSTRUCTIONS
C AUTION
Prior to using a new unit, wipe the surface with a wet cloth and wash the removable accessories in warm
water due to hygienic reasons.
The unit has a built-in safety catch. The motor can be switched on only if the accessories are properly
mounted. Do not bypass the safety mechanism!
Never leave the appliance unattended while it is running or connected to the mains.
Some parts may keep moving for a while immediately after the motor has been switched off and the power
cord disconnected from the socket. Wait until the accessories stop completely and only then open the lid.
Using your blender
1. Place the Jar onto Blender Motor Base. Before operation, recheck the Jar base is fixed well on the
blender Motor Base or not. If not, adjust a little bit direction of driving shaft of Blade under Jar base for a
easy insert into Motor Driver Gear of Blender Motor Base.
2. Put the ingredient into Jar and then cover the lid back
3. Plug into the power source
4. Settle "ON" or "Stepless Speed" SWITCH controls to start the processing.
5. Ingredient could be added into Jar through Small cup in the lid
6. Take away the Jar from Blender Motor Base only when the motor is stop.
WARNING
Hot food mixes at the lowest speed, if necessary, add speed. Do not use smoothie, there is a risk of splashing
hot liquid from the container and scalding.

CLEANING AND MAINTENANCE

1. Before cleaning remove the power cord from the socket.
2. Never immerse the housing with motor in water!
3. Do not use any sharp or abrasive detergents.
4. Only a damp rinsing cloth should be used to clean the outside of the housing.
5. Components that have come into contact with food can be cleaned in soapy water.
6. Allow the parts to dry thoroughly before reassembling the device.
SERVICING
Any extensive maintenance or repair that requires access to the inner parts of the product must be
performed by an expert service centre.
36

ENVIRONMENTAL PROTECTION

• Packaging materials and obsolete appliances should be recycled.
• The transport box may be disposed of as sorted waste.
• Polyethylene bags shall be handed over for recycling.
Appliance recycling at the end of its service life:
A symbol on the product or its packaging indicates that this product should not go into
household waste. It must be taken to the collection point of an electric and electronic
equipment recycling facility. By making sure this product is disposed of properly, you will
help prevent the negative effects on the environment and human health that would
otherwise result from inappropriate disposal of this product. You can learn more about
recycling this product from your local authorities, a household waste disposal service or in
the shop where you bought this product.
SM 3410 SM 3410
EN
37