Operation And Configuration Precautions; Compliance With International Standards; Noise; Rf Interference - Digital Projection LIGHTNING 35HD-T Wichtige Informationen

English

Operation and configuration precautions

Do not try to operate the touch screen using anything harder than your finger. This could damage the LCD.
Do not make changes to the networking configuration unless you understand what you are doing, or have taken
advice from your Network Manager. If you make a mistake, it is possible that you will lose contact with the
projector. Always double-check your settings before pressing the APPLY button. Always keep a written note
of the original settings, and any changes you have made.
Software update should NOT be carried out except by, or with the supervision of, Digital Projection Service
personnel.

Compliance with international standards

Noise

GSGV Acoustic Noise Information Ordinance
The sound pressure level is less than 70 dB (A) according to ISO 3744 or ISO 7779.

RF Interference

FCC
The Federal Communications Commission does not allow any modifications or changes to the unit EXCEPT those specified by
Digital Projection in this manual. Failure to comply with this government regulation could void your right to operate this
equipment.
This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant with Part 15 of the
FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is
operated in a commercial environment. This equipment generates, uses, and can radiate radio frequency energy and, if not
installed and used in accordance with the instruction manual, may cause harmful interference to radio communications.
Operation of this equipment in a residential area may cause harmful interference, in which case the user will be responsible for
correcting any interference.
European Waste Electrical and Electronic Equipment (WEEE) Directive
Digital Projection Ltd is fully committed to minimising Waste Electrical and Electronic Equipment. Our products are
designed with reuse, recycling and recovery of all components in mind. To this end, at end of life, your projector may be
returned to Digital Projection Ltd or its agent so that the environmental impact can be minimised.

Specifications

Part numbers

Projector
USA model
Rest of World model
Digital Projection
LIGHTNING 35/40HD-T, 30/40sx+m, 30/40sx+c
35HD-T: 105-033
40HD-T: 106-264
35HD-T: 105-034
40HD-T: 106-265
January 2007
30sx+m: 107-148
40sx+m: 107-150
30sx+m: 107-149
40sx+m: 107-151
Page 7
30sx+c: 105-838
40sx+c: 106-692
30sx+c: 105-839
40sx+c: 106-693