Installation Precautions - Digital Projection LIGHTNING 35HD-T Wichtige Informationen

Digital Projection
LIGHTNING 35/40HD-T, 30/40sx+m, 30/40sx+c

Installation precautions

Connect the LAN cable only to a computer LAN connection. Other similar connectors may have a dangerously
high voltage source.
The projector must be installed only by suitably qualified personnel, in accordance with local building codes.
The projector should be installed as close to the power outlet as possible.
The power connection should be easily accessible, so that it can be disconnected in an emergency.
Ensure that there is at least 30cm (12in) of space between the ventilation outlets and any wall, and 10cm (4in) on
all other sides.
Do not install the projector close to anything that might be affected by its operational heat, for instance,
polystyrene ceiling tiles, curtains etc.
The projector weighs over 100kg (200lbs). Use safe handling techniques when lifting the projector.
When stacking projectors, the stack MUST be vertical, to ensure that the stresses are distributed to all for frame
couplings.
Before installation, make sure that the surface, ceiling or rigging that is to support the projector is capable of
supporting the combined weight of the projector and lens (see specification for exact weights).
Separate backup safety chains or wires should always be used for each projector.
Do not place heavy objects on top of the projector chassis. Only the rigging frame is capable of withstanding the
weight of another projector.
Do not stack more than four projectors.
Do not drop or jarr the projector.
Place the projector in a dry area away from sources of dust, moisture, steam, smoke, sunlight or heat.
Each time a new lens is fitted to the projector, the calibration procedure must be carried out. See Lens menu, in
Section 4. Using the menus.
The zoom drive mechanism should always be set to the engaged position, even when using the non-zoom lens,
as it provides an extra level of protection, should the lens release lever fail.
Do not tilt the projector more than ±12° from side to side when in use, as this may cause serious lamp failure,
damage the lamp module and cause extra cost on replacement. The projector my be tilted forwards and
backwards as necessary.
±12°
January 2007
360°
Page 6
English