Product Overview - Toro 1800 Power Curve 38302 Bedienungsanleitung

Operation

Product Overview

1. Rotor blades
2. Belt cover (not shown)
3. Chute deflector
4. Chute deflector trigger
5. Discharge chute handle
6. Cord guide
7. Interlock button
Important:
This machine is intended for outdoor,
residential use only. Do not use it indoors or for commercial
or industrial purposes.
Connecting to a Power
Source
To reduce the risk of electric shock, this machine has a polarized
plug (i.e., 1 blade is wider than the other). Use only a polarized
plug, UL-listed (CSA certified in Canada) extension cord
recommended for outdoor use. A polarized plug will fit in a
polarized cord only one way. If the plug does not fit fully in the
cord, reverse the cord. If it still does not fit, purchase a polarized
extension cord. If you have a polarized extension cord and the
extension cord plug does not fit fully into the wall receptacle,
reverse the plug. If it still does not fit, contact a qualified electrician
to install the proper outlet. Do not change the machine or
extension cord plug in any way.
Figure 8
8. Power control bar
9. Upper handle
10. Cord
11. Chute control rod
12. Handle knobs
13. Discharge chute
DANGER
Contact with water while operating the machine could
cause electric shock, causing injury or death.
•
Don't handle the plug or the machine with wet
hands or while standing in water.
•
Use only an extension cord recommended for
outdoor cold-weather use.
Extension Cord Length
25 ft
50 ft
100 ft
150 ft
Note:
Do not use an extension cord over 150 ft.
Important:
Check the extension cord frequently during
use for holes or cracks in the insulation. Do not use a
damaged cord. Do not run the cord through standing water
or wet grass.
Note:
To prevent the extension cord from disconnecting during
operation, use the cord lock on the upper handle before you
connect it to the machine
g220753
1. Cord lock
WARNING
A damaged appliance cord can cause a shock or fire.
Thoroughly inspect the appliance cord before using
the machine. If the cord is damaged, do not operate the
machine. The supply cord or switch of this equipment
cannot be replaced, and the equipment shall be
scrapped.
6
Minimum Wire Gauge
(A.W.G.)
16
16
16
14
(Figure 9).
Figure 9
2. Extension cord
g220754