Toro 1800 Power Curve 38302 Bedienungsanleitung Seite 5

Setup
Note:
Determine the left and right sides of the machine from
the normal operating position.
Installing the Upper Handle
1. Remove the handle knobs, oval bolts, and curved washers
from the lower handle.
2. Install the upper handle to the lower handle of the machine
with the handle knobs, curved washers, and oval bolts as
shown in Figure 1.
1. Handle knob (2)
2. Curved washer (2)
3. Oval bolt (2)
Note:
Ensure that the power cord attached to the machine
is routed over the lower handle and to the inside of the
handle assembly.
3. Tighten the handle knobs firmly by hand.
4. Attach the cord guide to the handle
Figure 1
4. Lower handle
5. Upper handle
(Figure 2).
1. Cord guide
2. Handle
Installing the Chute Control
Rod
1. Position the discharge chute so that it faces forward.
Important:
with the arrow on the housing
g013476
1. Discharge chute
2. Insert the end of the chute control rod through the keyed
hole in the bracket that is attached to the top of the lower
handle (Figure
4
Figure 2
3. Cord
Align the arrow on the discharge chute
(Figure 3).
Figure 3
2. Align the arrows
4).
g287698
g013454