Dust/Chip Extraction - Bosch GST 85 PE Bedienungsanleitung

If other cutting angles are required, these should
be set exactly using, for example, a commercially
available protractor 16.
When returning the base plate to the 0° (normal)
position, press the base plate lightly in the direc-
tion of the motor until it can be felt to engage and
again tighten the screw 15.
Offsetting the Base Plate
(see figure
A
For sawing close to edges, the base plate can be
offset to the rear:
GST 85 PAE: Remove the cover guard 12 and
open the slider 22 at the bottom side of the base
plate.
Use Allen key 3 to take out screw 15 completely.
Lift the base plate and move it to the rear such
that the screw can be turned into the rear thread.
When tightening the screw 15, the base plate
must be pressed to the rear until it can be felt to
engage.
– With the base plate offset, only the 0° (normal)
position can be used.
– The circle cutter/parallel guide 23 as well as
the splinter guard 19 cannot be used in this
case.
Replaceable Base-plate Covers
(GST 85 PAE – see figure
The base plate 8 is originally equipped with a re-
placeable base-plate cover 21 made of plastic. It
ensures good sliding capability on wood and
plastic surfaces, and largely avoids scratching of
sensitive surfaces.
After loosening the six screws 20, the replacea-
ble plastic base-plate cover can be exchanged
against a steel insert, which is intended for use on
metal surfaces.
15 • 2 609 931 878 • TMS • 26.09.02
)
)
B
Splinter Guard (see figure
To avoid fraying of the surface, install the splinter
guard 19 by pressing it into the base plate 8.
The splinter guard cannot be used for certain saw
blade types (e. g., saw blades with set teeth).

Dust/Chip Extraction

(GST 85 PAE)
The dust that is produced while working can be
detrimental to health, inflammable or explosive.
Suitable safety measures are required.
Examples: Some dusts are regarded as carcino-
genic. Use suitable dust/chip extraction and wear
a dust respirator.
Dust from light alloys can burn or explode. Al-
ways keep the workplace clean, as blends of ma-
terials are particularly dangerous.
The machine can be plugged directly into the re-
ceptacle of a Bosch all-purpose vacuum cleaner
with remote control starting. The vacuum cleaner
starts automatically when the machine is
switched on.
The vacuum cleaner must be suitable for the ma-
terial to be worked.
When vacuuming dry dust that is especially detri-
mental to health or carcinogenic, use a special
vacuum cleaner.
For external dust extraction with a vacuum
cleaner, an extraction adapter must be used as
required (see accessories). Insert extraction
adapter and vacuum connection firmly.
Attach the vacuum connection 5 to the base
plate 8 and connect the extraction hose.
For low blowing effect, set the sawdust blower
switch 6 upward.
Cover Guard
The transparent cover guard 12 enables the col-
lection of chips and sawdust. To achieve opti-
mum results, it must always be mounted when
working with dust extraction.
English - 4
)
B