Protection Functions; Over-Temperature Protection - Klarstein TrinityCook Bedienungsanleitung

EN
30
4. If "E0" is shown on the cooking zone display (5), the induction hob has not
detected any ferromagnetic metal cookware, which means that the cookware used
is unsuitable. Use cookware made of ferromagnetic metal.
CAUTION
Risk of burns! The accessible surfaces of the appliance can become
very hot during operation.

PROTECTION FUNCTIONS

Over-temperature protection

The appliance is equipped with a temperature sensor device to monitor the temperature
inside the hobs. When an excessive temperature is detected, both the Induction Hob
and the Hi-Light Ceramic Hob will stop increasing temperature automatically.
Detection of small articles (Induction Hob)
When the Induction Hob detected the existence of a pot which is less than 80 mm in
diameter or small articles (e.g. knife, fork, forceps, key, etc.) or non-magnetic pots (such
as aluminium or bronze pot), the buzzer can gives out an alarm lasting about 1 minute.
In case user has not put proper pot in time, the Induction Hob shall automatically switch
to standby mode.
Residual heat after use
When the hob is used for a long period of time, heat remains in the heating zone for a
few minutes.
Auto shutdown protection
Auto shutdown is a safety protection funtion of the appliance. If not turned-off after
120 minutes, it will shuts down automatically.
When pot is removed, the induction hob shall stop heating immediately and shut down
after 1 minute of buzzer sound.