Maestro MR 851 Bedienungsanleitung Seite 6

- Press the fasten button hold the head and insert it into the inlet(when inserting please pay
attention the head must be slanted as per arrow indicated on the top, see fig.2.1,then move the head
anticlockwise so that the head being fastened tightly (fig.2.2)
fig.2.2
- Place the snake into the head, long end first, and turn to feed the screw slightly until it is set into the
motor housing (fig. 2.3)
- Place the cutting blade onto the snake shaft with the blade facing the front as illustrated (fig.2.4).
If it is not fitted properly, meat will not be grinded.
fig.2.3
- Place the desired cutting plate next to the cutting blade, fitting protrusions in the slot (fig.2.5)
- Support or press the center of the cutting plate with one finger then screw the fixing ring tight with
another hand (fig.2.6). Do not over tighten.
6
ASSEMBLING
fig.2.4