Getting Started; Installing The Power Supply Unit; Assembling The Power Supply Unit; Dismantling The Power Plug Adapter - Sartorius Entris BCE series Betriebsanleitung

6

Getting Started

6.1

Installing the Power Supply Unit

6.1.1

Assembling the Power Supply Unit

Item number Power supply unit YEPS01-15VOW with
on packaging connection cable and country-specific
power plug adapters (packed in PE bag
with printed country identification,
e.g. EU)
YEPS01-PS8 USA and Japan (US+JP), Europe and Russia
(EU+RU), Great Britain (UK), India (IN),
South Africa (ZA), Australia (AU), China (CN)
YEPS01-PS9 Argentina (AR), Brazil (BR), Korea (KR)
YEPS01-PS10 China (CN)
Procedure
Push the power plug adapter as far as you can until it
t
clicks into place .
Check whether the power plug adapter is securely locked
t
in place by pulling it gently .
If the power plug adapter does not move: It is locked in
y
place .
6.1.2

Dismantling the Power Plug Adapter

Procedure
Select the country-specific
t
power plug adapter . The
power plug adapter must be
suitable for use with the wall
outlet at the installation site .
Insert the power plug adapter
t
into the power supply unit .
The grooved button must be
facing upwards .
Press the grooved button
t
from above and pull back on
the power plug adapter .
Push the power plug adapter
t
out of the power supply unit
and remove it .
6.2

Connecting the Power Supply

Procedure
WARNING Severe injuries caused by using defective
t
power supply cables! Check the power supply cable for
damage, e .g . cracks in the insulation .
If required: Contact Sartorius Service .
t
Check whether the country-specific power plug matches
t
the power connections at the installation site .
If required: Replace the country-specific power plug
t
adapter .
NOTICE Damage to the device due to excessive input
t
voltage! Check whether the voltage specifications on the
manufacturer's ID label match those of the power supply
at the installation site .
If the input voltage is too high: Do not connect the
t
device to the power supply .
Contact Sartorius Service .
t
Connect the right angle plug to the "Power Supply"
t
connection .
Connect the mains plug to the wall outlet (mains voltage)
t
at the installation site .
The [BOOTING] display appears in the operating display .
y
The device performs a self-test .
y
7

System Settings

7.1

Performing System Settings

Default settings can be adjusted for the device and the
applications in order to align with the ambient conditions
and individual operating requirements .
The following settings are necessary to operate the device
together with connected components:
− Set up the communication of the connected devices
− Set up additional components
The following settings are recommended to set up the device:
− Set the menu language
− Set the date and time
− Set the calibration and adjustment
Procedure
Press the [Menu] button .
t
To adjust settings: Open the desired menu .
t
Select and confirm the desired parameter (parameters,
t
see Chapter "7 .3 Parameter List", page 19) .
Exit the menu .
t
Entris ®
Getting Started
BCE Operating Instructions 17