What To Do If Trouble Occurs - Teka 227735 R11 Gebrauchs- Und Montageanweisung

What to do if trouble occurs

What to do if trouble occurs
Interference with and repairs to the appliance by unqualified per-
sons are dangerous as they can result in an electric shock or a
short circuit. Do not interfere with or try to repair the appliance;
this could cause injury to persons and damage to the appliance.
Always have such work done by an expert, e.g. a Customer
Service technician.
Please note
If your appliance is faulty, please check whether you can rectify
the problem yourself by consulting these instructions for use.
You may be able to rectify some problems yourself. They are
described below.
The fuses blow regularly?
• Contact a technical customer service or an electrician!
You can't switch your hob on?
• If initial operation was not carried out properly by connecting
the hob to the mains (matching the sensors), the sensor keys
will not respond correctly when touched.
The hob will need to be disconnected from the power supply
for at least 10 seconds and will then need to be re-connected.
Important: the sensor keys must remain unused!
See too the section on "Putting the appliance into operation".
• Has the wiring system (fuse box) in the house blown a fuse?
• Has the hob been connected to the mains?
• Are the sensor keys locked, i.e. does the control lamp above
the lock key light up?
• Is the childproof lock activated, i.e. does the display show an
"L"?
• Are the sensor keys partly covered by a damp cloth, fluid or a
metallic object? Please rectify.
28
The symbol will blink and a time-limited continuous
signal will sound.
Food which has boiled over, cookware or other items are causing
the touch control sensor buttons to be consistently operated.
Remedy: clean the surface or remove the item.
To delete the symbol press the same button or switch the hob
off and on.
The hob or a cooking zone has suddenly switched off
• Did you accidentally press the ON/OFF key?
• Are the sensor keys partly covered by a damp cloth, fluid or a
metallic object? A buzzer will sound briefly. After a few sec-
onds the appliance will switch off. Please remove the item
located in front of the sensor keys.
• Has the safety cut-off device been activated, i.e. was a cook-
ing setting operated unchanged beyond a specific period of
time? See the section on "operation time limit".
Does the display show an Fx error code after the plug has
been put in and the appliance aligned?
• F1: The surroundings are still too bright (e.g.: sun or reflector
lamps)
• F2: Strongly pulsating light (fluorescent lamp)
• F3: Button covered with a bright object
• F4: Surrounding light varies greatly
Remedy for all error codes: reduce the surrounding light and
remove objects from the sensor buttons.
Cooking zone cannot be switched off.
• Faulty electronic component.
Disconnect the fuse, call Customer Service.
Cooking zone does not heat up.
• Cooking zone defective. Call Customer Service.
• Inner circuit of a multi-circuit cooking zone defective.
Under no circumstances continue to use the outer circuit which
is still working! Immediately call Customer Service.
Does the hob make noises (clicking or cracking noises) or
can a buzzing sound be heard when the hob is switched on?
• This is design-specific and has no influence on quality and
operation.
LED display for cooking settings and residual heat display H
does not come on or only partially.
• LED display defective. Call Customer Service.
Risk of burning, as the temperature warning is not guaranteed.
Does the hob have tears or cracks?
• There is a risk of electric shocks if the glass ceramic hob
develops fractures, cracks, tears or damage of any other kind.
Immediately switch off the appliance. Disconnect the fuse
immediately and call Customer Service.
GB