Setting Menu; Information Menu; Mowing Tips - AL-KO Robolinho 4000 Originalbetriebsanleitung

en
3. Use the [up arrow key] or the [down arrow key]
to select the [Point X*] menu item until the star
symbol appears to the left of the menu item.
4. Set the required distances and set additional
entry points if necessary.
5. Confirm with the [multifunction key right].
6. Press the [menu key] again to return to the
main menu.
By default, the first entry point is al-
ways 1 m to the right of the base sta-
tion, and cannot be changed.
By default, another 9 entry points
are distributed along the overall
length of the boundary cable (after
the 1st edge mowing or complete
loop movement).
These entry points can be changed
and programmed according to the
size and composition of the mowing
area.
Learning entry points
1. Press the [START/PAUSE key] to start the
procedure.
Follow the instructions on the display.
[Learn entry points]
2. Set entry point X.
3. Position: Set Y with the [multifunction key
right].
No entry point is set.
The loop length is measured and the
start points are automatically distri-
buted evenly over the length.
The entry points can be adapted
manually.

SETTING MENU

Set the data, time, language and recalibrate, see
start-up.
Activate or deactivate the button tones
1. Select [button tones].
2. Confirm with the [multifunction key right] (3-5).
3. Activate or deactivate the button tones with
the [multifunction key right] (3-5).
4. Confirm the corresponding selection with the
[menu key] (3-8).
Activating or deactivating the rain sensor
1. In the Settings sub-menu, select [Rain sen-
sor].
34
2. Confirm with the [multifunction key right].
3. Activate or deactivate the rain sensor with the
[multifunction key right].
4. Confirm the selection with the [menu button]
and return to the main menu.
Setting the rain sensor delay
1. In the Settings sub-menu, select [Rain sensor
delay].
2. Confirm with the [multifunction key right].
3. Set the [Rain sensor delay].
4. Confirm the selection with the [menu button]
and return to the main menu.
The purpose of the [Rain sensor de-
lay] function is to instruct the Robolinho
4000 to move back out of the base sta-
tion after a time delay, after it has retur-
ned to the base station.
Changing the display contrast
1 Select [Display contrast].
2 Select [Display contrast] with the [arrow keys]
(3-3) and confirm with the [multifunction key
right] (3-5).
3 Confirm the selection with the [menu key]
(3-8) and return to the main menu.
Restoring factory settings
1 Select [Factory settings].
2 Enter the PIN code again and confirm.
3 Confirm the selection with the [menu key]
(3-8) and return to the main menu.

INFORMATION MENU

The information menu is used for calling up the
software status, hardware status, current settings
(program info) and faults. No settings can be
made in this menu.
Faults
Display of date, time and fault code with fault mes-
sage. All fault messages since start-up are listed.

MOWING TIPS

Cutting height at a constant 3 - 6 cm, do not
mow off more than half of the lawn height.
Adjust the mowing times accordingly.
If the motor speed drops noticeably because
of thick grass, increase the cutting height and
mow in several passes.
Program menu
©
Robolinho 4000
©