OSRAM e:cue Bridge8 Bedienungsanleitung Seite 27

Open the Test mode page by selecting "TestMode" on the left side of the
web interface of the e:cue Bridge8:
Fade:
dimming up and
down, alternating
Click a button to choose a test pattern. Define the properties:
Property
Output
Channel Count
Block Size
Offset
Value
Step Time
Click "set" to run the test and to apply changes in the test settings.
Exit the Test mode by leaving the Test mode page, e.g. go to "Dashboard"
or double-pressing the Identify button.
Strobe: Const:
fast flashing constant lighting
Description
DMX ports to run the test on.
Total frame length.
Block size in which to step through the frame length
in channel count.
Start address of the first test loop (first channel = 1).
Luminance of the test output (0 - 255).
Delay between steps. Manual: Press the Test button
to move the block. Define the first channel at "Start
Address".
Chase:
consecutive lighting
of blocks
Test mode
27