OSRAM e:cue Bridge8 Bedienungsanleitung Seite 23

configure first its protocol and parameters.
Protocol Source
sACN 1, 2
Art-Net 1, 2
Then map the input data to the previously configured output ports:
Universe a
1. Open the sources' configuration pages by selecting "Input
Source 1" and "Input Source 2" respectively on the left side of the web
interface of the e:cue Bridge8:
1.
Please note that the IP addresses of the two sources must be different if
the same protocol is used for both sources. You can have an identical IP
address when two different protocols are used.
Port Number
5568
6454
Source 1
take channels
starting at offset1
4.
Data mapping
yes
yes
Port x
2.
3.
Output configuration
Output for Source 1
length
23