Output Configuration - OSRAM e:cue Bridge8 Bedienungsanleitung

i
You can change the login password to the e:cue Bridge8's
configuration page and its device name at "Settings" page.
Do not forget the new password.
i
The e:cue Bridge8 should be only accessed from one
browser tab at a time.
In case there is no response please wait a while or reopen
the browser to end pending connections.
i Please note that after changing the IP address, the device
currently will lose its connection and needs to be
reconnected under the new IP address.
6

Output configuration

Access the web interface to first configure the data output of each port and
to secondly map the data input of two sources. Then define a third source
that determines the switching between the two input sources. Alternatively
you can switch between the input sources manually over the web interface.
For each of the eight ports, the data output is composed of maximum one
DMX universe:
Source 1
Universe a
To access the web interface, open a common web browser on a connected
PC. Enter the e:cue Bridge8's IP address into the address bar:
e.g. http://192.168.123.1.
Port x
take channels
starting at offset1
Output configuration
Output for Source 1
length
21