Test Mode - OSRAM e:cue Bridge8 Bedienungsanleitung

1. Open the source switch configuration page by selecting "Source
Switch Settings" on the left side of the web interface of the
e:cue Bridge8:
1.
2. Select a protocol type (Art-Net, sACN, or none) from the drop
down menu. Enter the IP address of the switch source and define the
universe and channel that is to determine the switching between
Source 1 and Source 2. For sACN you can chose between Multicast
and Unicast transmission by selecting the "Multicast" checkbox.
3. Click the "submit" button to save the configuration.
For manual source switching, you can click on the buttons at the end of the
page. Please note that if the source is configured properly, the manual
switching command will be overwritten by any incoming source value. To
prevent overwriting, either set the "Channel" to 0 or select "none" as
protocol type.
7

Test mode

The e:cue Bridge8 provides a Test mode for the connected DMX devices.
The Test mode is designed for DMX luminaires. There are two kinds: using
the Test button and using the web interface of the e:cue Bridge8.
Please note that the Test mode overwrites all other DMX output like running
shows for the time of testing. A running show is reverted to after exiting the
2.
3.
Test mode
25