Specifications - Makita DHS680 Betriebsanleitung

ENGLISH (Original instructions)
1. Button
2. Red indicator
3. Battery cartridge
4. Switch trigger
5. Lock-off lever
6. Battery indicator
7. Mode indicator
8. Lever
9. Depth guide
10. Front lever
11. Stopper
12. Cutting line (0° position)
13. Cutting line (45° position)

SPECIFICATIONS

Model
Blade diameter
Max. cutting depth
No load speed
Overall length
Net weight
Rated voltage
• Due to our continuing program of research and development, the specifications herein are subject to change without
notice.
• Specifications and battery cartridge may differ from country to country.
• Weight, with battery cartridge, according to EPTA-Procedure 01/2003
Intended use
The tool is intended for performing lengthways and
crossways straight cuts and mitre cuts with angles in
wood while in firm contact with the workpiece. With
appropriate Makita genuine saw blades, other materials
can also be sawed.
General Power Tool Safety
Warnings
WARNING Read all safety warnings and all
instructions. Failure to follow the warnings and
instructions may result in electric shock, fire and/or
serious injury.
Save all warnings and
instructions for future reference.
CORDLESS CIRCULAR SAW
SAFETY WARNINGS
Cutting procedures
1. DANGER: Keep hands away from cutting area
and the blade. Keep your second hand on
auxiliary handle, or motor housing. If both hands
are holding the saw, they cannot be cut by the blade.
6
Explanation of general view
14. Screw
15. Lamp
16. Hook
17. Close
18. Open
19. Hex wrench
20. Shaft lock
21. Tighten
22. Loosen
23. Inner flange
24. Saw blade
25. Outer flange
26. Hex bolt
at 0°
at 45°
at 50°
2. Do not reach underneath the workpiece. The guard
ENE078-2
3. Adjust the cutting depth to the thickness of the
4. Never hold piece being cut in your hands or
GEA010-1
5. Hold the power tool by insulated gripping surfaces
6. When ripping, always use a rip fence or straight
GEB060-8
7. Always use blades with correct size and shape
8. Never use damaged or incorrect blade washers or
27. Mounting shaft
28. Ring
29. Dust nozzle
30. Vacuum cleaner
31. Hose
32. Clamping screw
33. Rip fence (Guide rule)
34. Adjusting screw for 45°
35. Adjusting screw for 0°
36. Triangular rule
37. Bevel guide
38. Guide
DHS680
165 mm
57 mm
41 mm
37 mm
5,000 min
350 mm
3.3 kg
D.C. 18 V
cannot protect you from the blade below the
workpiece.
workpiece. Less than a full tooth of the blade teeth
should be visible below the workpiece.
across your leg. Secure the workpiece to a stable
platform. It is important to support the work properly
to minimize body exposure, blade binding, or loss of
control. (Fig. 1)
A typical illustration of proper hand support and
workpiece support.
only, when performing an operation where the
cutting tool may contact hidden wiring. Contact
with a "live" wire will also make exposed metal parts of
the power tool "live" and could give the operator an
electric shock.
edge guide. This improves the accuracy of cut and
reduces the chance of blade binding.
(diamond versus round) of arbour holes. Blades
that do not match the mounting hardware of the saw
will run eccentrically, causing loss of control.
bolt. The blade washers and bolt were specially
-1