Optional Accessories - DeWalt DWS520 Originalanweisungen

1. Set the speed of the plunge saw to level 5.
2. Place the guide rail on a scrap piece of wood.
3. Set the plunge saw on 5 mm cut depth
4. Place the saw on the rear end of the guide rail.
5. Turn the saw on, press it down to the set
cutting depth and cut the splinterguard along
the full length in one contiuous operation. The
edge of the splinterguard now corresponds
exactly to the cutting edge of the blade.
WARNING: To reduce the risk of injury,
ALWAYS secure the guide rail (w) with a
clamp.
Speed Adjustment (fi g. 1)
The speed can be regulated between 1750 and
4000/min using the speed wheel (s). This enables
you to optimise the cutting speed to suit the
material. Refer to the following chart for type of
material and speed range.
Type of Material
to be Cut
Solid wood (hard, soft)
Chipboards
Laminated wood, blockboards,
veneered and coated boards
Paper and carton
Wall Cutting (fi g. 7)
1. Place the plunge saw with the outer guard (v)
on a clean, flat floor.
2. Press the shoe (d) with the front side on the
door against the adjusted depth stop.
Dust Extraction (fi g. 1)
Your tool is fitted with a dust extraction outlet (i).
WARNING: ALWAYS connect the
plunge saw to a dust extractor!
WARNING: ALWAYS use a dust
extraction device designed in
accordance with the relevant regulations
regarding dust emission.
MAINTENANCE
Your D WALT power tool has been designed to
E
operate over a long period of time with a minimum
of maintenance. Continuous satisfactory operation
depends upon proper tool care and regular cleaning.
WARNING: To reduce the risk of
injury, turn unit off and disconnect
machine from power source before
installing and removing accessories,
before adjusting or changing set-
ups or when making repairs. Be sure
the trigger switch is in the OFF position.
An accidental start-up can cause injury.
WARNING: If the saw blade is worn
replace it with a new sharp blade.
Lubrication
Your power tool requires no additional lubrication.
Cleaning
Speed
WARNING: Blow dirt and dust out of
Range
the unit with dry air as often as dirt is
3–5
seen collecting in and around the air
4–5
vents. Wear approved eye protection
and approved dust mask when
2–5
performing this procedure.
1–3
WARNING: Never use solvents or
other harsh chemicals for cleaning the
non-metallic parts of the tool. These
chemicals may weaken the materials
used in these parts. Use a cloth
dampened only with water and mild
soap. Never let any liquid get inside the
tool; never immerse any part of the tool
into a liquid.

Optional Accessories

WARNING: Since accessories, other
than those offered by D
not been tested with this product, use
of such accessories with this tool could
be hazardous. To reduce the risk of
injury, only D
accessories should be used with this
product.
D WALT offers saw blades specially designed for
E
your plunge saw.
Consult your dealer for further information on the
appropriate accessories.
EN GL IS H
WALT, have
E
WALT, recommended
E
33