Herunterladen Inhalt Inhalt Diese Seite drucken

Replacing The Drive Belts; Replacing The Headlight; Storage; Storage Safety - Toro Power Max 726 OE Bedienungsanleitung

Vorschau ausblenden Andere Handbücher für Power Max 726 OE:
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 33

Replacing the Drive Belts

If the auger/impeller drive belt or the traction-drive belt
becomes worn, oil-soaked, or otherwise damaged,
have an Authorized Service Dealer replace the belt.

Replacing the Headlight

Model 38819 only
Replace the headlight assembly (Toro part number 138-0670) when needed.
1.
Remove the headlight wire from the back of the headlight (A of
2.
Remove the bolt and nut holding the headlight assembly onto the headlight bracket and then remove the
old headlight assembly (B of
3.
Secure the new headlight assembly onto the headlight bracket with the previously removed nut and
bolt (C of
Figure
4.
Insert the headlight wire straight into the back of the headlight until it is securely in place (D of

Storage

Storage Safety

Shut off the engine, remove the key, and wait
for all movement to stop before you leave the
operator's position. Allow the machine to cool
before adjusting, servicing, cleaning, or storing it.
Fuel fumes are highly flammable, explosive, and
dangerous if inhaled. If you store the product in an
area with an open flame, the fuel fumes may ignite
and cause an explosion.
Do not store the machine in a house (living
area), basement, or any other area where ignition
sources may be present, such as hot water and
space heaters, clothes dryers, furnaces, and other
appliances.
Figure
39).
39).
Figure
Figure 39
Do not tip the machine either forward or backward
with fuel in the fuel tank; otherwise, fuel may leak
out of the machine.
Do not store the machine with its handle tipped
down onto the ground; otherwise, oil may leak into
the engine cylinder and onto the ground, and the
engine may not start.

Storing the Machine

1.
On the last refueling of the year, add fuel
stabilizer to fresh fuel as directed by the fuel
stabilizer manufacturer.
Important:
than that suggested by the fuel stabilizer
manufacturer.
2.
Run the engine for 10 minutes to distribute the
conditioned fuel through the fuel system.
25
39).
Do not store fuel longer
Figure
39).
g256137

Quicklinks ausblenden:

Werbung

Inhaltsverzeichnis
loading

Diese Anleitung auch für:

Power max 826 oae

Inhaltsverzeichnis