Replacing The Drive Belts; Storage; Storage Safety; Storing The Machine - Toro Power Max 724 OE Bedienungsanleitung

Replacing the Drive Belts

If the auger/impeller drive belt or the traction-drive belt
becomes worn, oil-soaked, or otherwise damaged,
have an Authorized Service Dealer replace the belt.

Storage

Storage Safety

•
Shut off the engine, remove the key, and wait
for all movement to stop before you leave the
operator's position. Allow the machine to cool
before adjusting, servicing, cleaning, or storing it.
•
Fuel fumes are highly flammable, explosive, and
dangerous if inhaled. If you store the product in an
area with an open flame, the fuel fumes may ignite
and cause an explosion.
•
Do not store the machine in a house (living
area), basement, or any other area where ignition
sources may be present, such as hot water and
space heaters, clothes dryers, furnaces, and other
appliances.
•
Do not tip the machine either forward or backward
with fuel in the fuel tank; otherwise, fuel may leak
out of the machine.
•
Do not store the machine with its handle tipped
down onto the ground; otherwise, oil may leak into
the engine cylinder and onto the ground, and the
engine may not start.

Storing the Machine

1. On the last refueling of the year, add fuel
stabilizer to fresh fuel as directed by the fuel
stabilizer manufacturer.
Important:
Do not store fuel longer
than that suggested by the fuel stabilizer
manufacturer.
2. Run the engine for 10 minutes to distribute the
conditioned fuel through the fuel system.
3. Run the machine until the engine runs out of fuel.
4. Prime the engine and start it again.
5. Allow the engine to run until it shuts off.
When you can no longer start the engine, it is
sufficiently dry.
6. Allow the engine to cool.
7. Remove the key.
8. Clean the machine thoroughly.
9. Touch up chipped surfaces with paint available
from an Authorized Service Dealer. Sand
affected areas before painting, and use a rust
preventative to prevent the metal parts from
rusting.
10. Tighten all loose screws, bolts, and locknuts.
Repair or replace any damaged parts.
11. Cover the machine and store it in a clean, dry
place out of the reach of children.
25