Lionelo Hugo Bedienungsanleitung Seite 9

How to assemble safety seat
Assembly with seatbelt
1.
Fastening seatbelts
•
Place the safety seat on the car seat. Make sure the safety seat backrest fits
tight to the seat backrest (fig. 7).
•
Place the child in the safety seat.
•
Pull the seatbelt, carry in front of the child and fasten it (8a).
2.
Placing seatbelt in the safety seat handle
•
From the seatbelt fastening side - carry the hip part through the red indicator
under the elbow rest (8a, 8e).
•
The arm part must be carried above the elbow rest.
•
On the other side – carry the hip part through the red indicator under the
elbow rest (8c).
•
Remember that the hip part of the seatbelt must be carried as low of the
child's hips as possible.
•
Carry the arm part of the seatbelt through the red handle in the headrest (8d).
•
Make sure the arm part of the seatbelt goes through the collarbone, instead
of neck.
Assembly with ISOFIX system
1.
Press button on ISOFIX fixing arm and pull it out as far as you can (fig. 9).
2.
Slip the safety seat in ISOFIX fixing in the car until you can hear clicks on
both sides. There should be a green button on the arm (fig. 10).
3.
Make sure the safety seat has been secured properly. If it sticks out or moves,
repeat the assembly (fig. 11).
Once you have assembled the seat, make sure that the safety seat has been
secured properly again:
1.
Hip part of the seatbelt must go through red indicators under elbow rests
on the seat (fig. 12-1).
2.
Arm part goes above the elbow rest from the belt fastening side (fig. 12-2).
3.
Arm part of the belt goes through the handle under the headrest (fig. 12-3).
4.
Seatbelts are tense and must not be twisted.
5.
Seatbelt fastening is not under the elbow rest (fig. 13).
‑ 9 ‑ EN