Lionelo Aart Bedienungsanleitung Seite 9

CHILD SAFETY SEAT BELTS
To fasten child safety seat belts:
1.
Connect belts to each other.
2.
Insert them into the buckle, you will hear a distinctive click.
3.
Make sure the belts are properly tight and not twisted. To undo the belts, press the
red button on the buckle (fig. 4).
How to adjust child safety seat belts tension
1.
Make sure the child safety seat belts adhere to the child's body properly and are not
twisted.
2.
To tighten the belts, pull the tension adjusting strap (fig. 9).
To release the belts, press the button (16) between the child's legs and pull the shoulder
belts (fig. 10).
To detach 5-point child safety seat belts:
1.
Press the button at the buckle and undo belts.
2.
Loosen the belts (see: How to adjust child safety seat belts tension).
3.
Detach belts from the buckle at the back of the child safety seat (fig. 5).
4.
Take belts out of the child safety seat through holes.
5.
Slide belts off the fasteners below the headrest, in the seat backrest (fig. 6).
6.
Position the child safety seat in a lying position (R).
7.
Slide the buckle off handles in the base, and then pull it through the hole in the seat
(fig. 7 and 8).
To reassemble the belts, retake the above-stated actions in a reversed order.
How to adjust the child safety seat belts height
The child safety seat belts height is adapted to the headrest height. To lift or lower the belts,
change the headrest height.
HEADREST HEIGHT
Height of the headrest must be adapted so that shoulder belts are at the child's arm height
(fig. 11):
A. TOO LOW
To set the headrest height, pull the headrest adjustment strap (fig. 12).
HOW TO REMOVE THE COVER
1.
Remove 5-point child safety seat belts.
2.
Remove the cover from the seat and backrest.
3.
Set the headrest as high as possible.
4.
Remove the cover from the headrest.
To attach the fabric cover again, retake the above-stated actions in a reversed order.
B. TOO HIGH
‑ 9 ‑
C. CORRECT
EN