Instructions For Operation; Operating Conditions; Personal Protective Equipment - HEYLO PV 6000 Betriebsanleitung

Fan PV 6000
– Always ensure that the device switch is
switched off before inserting the mains plug in
the mains socket.
– The device may only be moved when switched
off.

Instructions for operation

During operation, the following principles apply:
– Only a trained operator may work on the de-
vice.
– Children must be kept well away from the de-
vice.
– Do not modify, dismantle or take any safety
devices out of operation. The safety devices
must be inspected at regular intervals.
– All the covering panels, covers and hoods must
be installed as intended.
– Structural changes to the device are not al-
lowed.
– Always wear the prescribed personal protec-
tive equipment when operating the device.
Maintenance and troubleshooting
instructions
During maintenance and troubleshooting, the
following principles apply:
– Only suitably qualified staff may perform this
work on the device.
– The device must be switched off and the
mains plug pulled out of its mains socket.
13.1

Operating conditions

Under inadmissible operating conditions, the op-
erational safety and the performance of the device
may not be sufficiently ensured. Inadmissible op-
erating conditions must therefore be avoided at all
times.
The device must not be used in rooms with explo-
sive atmospheres.
24 / 36
The device is intended for mobile or stationary use
indoors, on construction sites and in garages and
storage spaces / rooms. The air temperature in
the device may not exceed 60 °C.
Only original spare parts or parts approved by the
manufacturer may be used.
The following conditions and safety rules must
always be adhered to.
– Always handle the device with care. Never
drop the device, throw it or transport it in any
vehicle without securing it properly.
– The device must be installed upright and sta-
ble. It must not fall over or slip even under full
load.
– Do not cover the device during operation.
– The device must not be operated in puddles or
in stagnant water. If the device or the connec-
tion cable gets wet then it must be dried thor-
oughly before the device may be operated.
– Make sure that the device does not suck in
any oil, grease or other contaminant.
– The mains voltage must correspond to the de-
tails on the rating plate.
– Extension cables must be selected according
to the performance data on the rating plate, in
order to prevent overload.
– The socket used must be earthed or protected
with a current operated earth leakage circuit
breaker when installed indoors.
People under the influence of alcohol, drugs or
medication must not operate or maintain the de-
vice.
13.2

Personal protective equipment

Personal protective equipment serves to protect
staff against any hazards that could affect their
safety or health at work.
The following personal protective equipment must
be worn during transport and installation:
EN