Restarting After An Unscheduled Downtime; Malfunctions During Operation; Troubleshooting Table; Cleaning And Maintaining The Device - HEYLO PV 6000 Betriebsanleitung

17.1 Restarting after an unscheduled
downtime
Power failure
After a power failure, the device will continue to
operate in continuous operating mode with the
device switch turned on.
17.2

Malfunctions during operation

Malfunc- Possible cause
tion
Device No or incorrect
motor is power supply
not running
Device switch not
ON
Turbine blade is
blocked
Device switch
broken off
Loose wiring
Device Motor mounting
operates bent so that tur-
but the bine blade jams.
turbine
blade runs
Major impact
irregularly
knocked the motor
or bumps
off its mounting
against
and jammed the
something
turbine blade.
Device Dirt accumulation
vibrates on the turbine
EN
Remedy
Check the power
cable and the
mains connection.
Turn the switch
ON
Turn device off
and allow to cool.
Then remove any
blockage.
Request replace-
ment switch from
your dealer or
HEYLO.
Check wiring and
retighten as need-
ed.
Remove motor
from housing,
replace or repair
bent mounting.
Remove the motor
from its housing
and reinsert cor-
rectly.
Clean the turbine
blade
Malfunc- Possible cause
tion
and is ex- blade
cessively
The device is not
loud
securely upright
Imbalance of tur-
bine blade
Turbine blade
bent
Motor shaft bent
Tab. 7:

Troubleshooting table

18 Cleaning and
maintaining the device
The following principles apply when cleaning and
maintaining the device:
These tasks may only be carried out by trained
and authorised specialists.
a) Switch off the device before starting work and
disconnect the mains plug.
b) Wear suitable personal protective equipment.
c) Before recommissioning, install all the safety
devices as attached at the factory.
d) Check that the safety devices are functioning
properly.
e) After completing the task, remove all the tools
and objects from the working area around the
device.
DANGER
Danger to life due to electric shock
Touching electrically live parts can be fatal.
a) Switch off the device and pull out the mains
plug.
Fan PV 6000
Remedy
Check installation
and correct if nec-
essary
Balance the tur-
bine blade or re-
place it
Replace the turbi-
ne blade
Replace the motor
29 / 36