Introduction; Operation Your Powervent 8000 - HEYLO PowerVent 8000 Bedienungsanleitung

1. Introduction

The PowerVent 8000 is a high-powered airmover for speed drying of building structures and
contents. It is designed for use in commercial carpet or hard surface floor cleaning or water
damage restoration, offering maximum airflow with minimal amp draw.
The PowerVent 8000 Features:
Two protective grills; with built-in duct connection
High powered airflow
0,75 kW motor
2. Operating your PowerVent 8000
Placement
For optimal wall and floor drying, place at least one PowerVent 8000 per room against walls
(with the Shell arrow pointed to the wall), with multiple units spaced 10-14 feet apart and facing
the same direction. Place as many as needed for maximum airflow across all wet areas of the
floor.
Ensure that all wet surfaces receive good airflow. Open interior doors to maintain good air
circulation. Doors may need to be braced to prevent them from blowing shut.
Getting Started
1. Place the unit in the desired operating position with the
airflow arrow pointing in the direction of the airflow.
2. Plug power cord into a standard 230 V grounded outlet.
3. Set the switch to the "ON" position.
4. Check for proper operation before leaving the unit unattended. Do not move or carry the
PowerVent 8000 when it is running.
Transporting
When transporting in a vehicle, secure the PowerVent 8000 and strap it into place to prevent
sliding and possible injury to the unit and vehicle occupants.
NOTICE! Store securely to avoid any damaging impact to the motor, blades and other internal
parts.
9 EN