Safety - HEYLO PV 6000 Betriebsanleitung

Address: HEYLO GmbH
Im Finigen 9
28832 Achim
Tel. no.: +49 (0) 4202 / 97 55 0
Fax: +49 (0) 4202 / 97 55 97
Email: info@heylo.de
Internet: http://www.heylo.de
Tab. 5:
Registered office
Address: HEYLO (Switzerland) AG
Südstraße 16
CH-3250 Lyss
Tel. no.: +41 (0) 32 / 387 16 80
Fax: +41 (0) 32 / 387 16 85
Email: info@heylo.ch
Internet: http://www.heylo.ch
Tab. 6:
Registered office in Switzerland
13

Safety

The device is built using state-of-the-art technol-
ogy and in accordance with the recognised safety
rules. Nonetheless, danger to the life and limb of
the operator or third parties may arise if it is not
used properly. Similarly, the device or other prop-
erty and material may become damaged.
The device must only be used:
– for the purpose for which it was intended
– and when it is in perfect technical condition.
The device must not be restarted until any fault
that may impair safety has been rectified.
Any persons installing, operating, maintaining or
cleaning the device must be aware of the hazards
that may arise from electrically operated equip-
ment in environments with a high humidity, and
they must have read and understood this operat-
ing manual.
EN
Avoiding dangerous situations
The following instructions apply to anyone work-
ing on or with the device:
– The operating manual must be kept at hand, in
complete and legible form, at the place where
the device is used.
– The device may only be used for its intended
purpose.
– The device must be fully functional and in
faultless condition. The condition of the device
must be checked regularly before use.
– Accident prevention regulations and any local
rules must always be adhered to.
Information on electrical equipment
During all work on electrical equipment, the fol-
lowing principles apply:
– The device is operated electrically. There is a
risk of fatal injury from faulty installation of
the electrical system or from a breakdown of
the insulation during operation.
– Only electricians are allowed to access and
work on electrical equipment. Always keep
switch-boxes closed.
– On completion of any work ensure that all
safety equipment is functioning properly.
– No unauthorised modifications may be made
to the device.
– The device is not approved for operation in ar-
eas with an explosive atmosphere.
Information on transport and installation
During transport and installation, the following
principles apply:
– Check the device on receipt and before every
use for visible turbine blade, covering or hous-
ing damage. Any and all such damage must be
rectified before the device may be operated.
– Always use the handle on the top of the device
when carrying it.
Fan PV 6000
23 / 36