General Information; Safety Instructions - HEYLO TD 2200 Bedienungsanleitung

Air Mover
TD 2200

1. General information

Introduction This section includes general information on the device and on the manual.
Target group
The manual is intended for service engineers installing the device, carrying out
maintenance work and changing defective parts.
Copyright Copying the manual, as a whole or in parts, is only permitted with the written
approval of HEYLO Drying Solutions GmbH !
Conditions HEYLO Drying Solutions GmbH reserves the right to make changes and
improvements to the product and manual without prior announcement or
notification.
Disposal The device is designed for long term operation. If it has to be disposed of, this
must take place in accordance with the respective legal regulations in an
environment friendly manner.
All devices have a CE mark

!! Safety instructions !!

Keep out of reach of children: Do not allow children to play with the device or near the device.
Electrical connection: Fans and ventilators are designed for operation at 230V/50Hz. Use only with a
plug with earthing contact! Sockets used must be earthed and have to save by a fault current
protection switch.
Protect power cable from damage: Never use the device with a damaged power cable. If the power
cable is damaged, it must be replaced by a cable of the same type and dimensions.
Extension cable: Only used approved extension cables!
Handle with care: Do not drop or throw the device since this could lead to damage of components or
wiring.
Place on a steady surface: Always place the device on a steady, even surface.
Make sure it is fixed in place during transport: Tie down the device during transport to prevent it
from slipping and sliding.
Keep it dry: The device cannot be operated in puddles or stagnant water. Do not store or operate it in
open spaces. If the electric wiring or parts of the device get wet, dry it thoroughly before using it again.
Keep the air vents free: Do not cover or block the air inlets and outlets.
12 EN