Vorwerk Kobold EBB100 Gebrauchsanleitung Seite 32

Kobold EB100 suction
power level
soft
med
max
32
Setting the brush mode
The Kobold EBB100 Electric Brush starts up in normal mode. You can
set the operating mode using the foot switch (1) on the electric brush.
1. Select the correct suction power level for your floor according to
the table
2. Press and release the foot switch (1) to change the brush mode.
The LEDs on the electric brush show which brush mode you are in.
3. Press and hold the foot switch (1) for approximately 2 seconds to
deactivate the brush.
The LEDs on the electric brush go out.
4. Press the foot switch (1) again to reactivate the brush.
Note To find out more about the 'Deactivate brush' mode, see chapter
"Troubleshooting
Note Every time you switch on your cordless vacuum cleaner, it will
automatically start operating on the 'med' suction power setting. The
electric brush will start in the mode that was last selected.
Brush mode recommendations
Normal brush mode
delicate floors
slightly dirty, delicate floors or very thick
carpets
extremely dirty, delicate floors
"Suitability of the accessory heads for floors
[} 37]".
Turbo brush mode
for providing a surface clean on
thicker carpets
all floors according to the table
"Suitability of the accessory
heads for floors [} 30]"
extremely dirty floors and
carpets (e.g. because of pet hair)
[} 30]".