During Operation; Starting The Machine; Using The Self-Propel Drive; Adjusting The Blade Speed - Toro Flex-Force Power System 60V MAX 36 cm Bedienungsanleitung

During Operation

Starting the Machine

1. Ensure that the battery pack is charged and
installed in the machine; refer to
Battery Pack (page
2. Install the safety key to the machine
Figure 10
3. Press the Power button at the center of the
upper handle to turn on the machine.
4. Squeeze the blade-control handles to start the
machine.
Installing the
11).
(Figure
Figure 11

Using the Self-Propel Drive

Model 21844/T Only
•
To adjust the self-propel movement speed,
adjust the speed control
•
To engage the self-propel drive, pull the
self-propel drive handles up to the handle and
hold them
10).
•
To disengage the self-propel-drive, release the
self-propel drive handles.
Note:
To reduce the ground speed, move the
speed control to the left; to increase, move it to
the right.
g344530
1. Self-propel speed control
2. MAX button
3. Self-propel drive handles

Adjusting the Blade Speed

This machine has 2 blade-speed settings: R
and M .
AX
•
When set to R
adjusted automatically for greater efficiency;
changes in cutting conditions are detected and
the blade speed increases when necessary to
maintain quality of cut.
•
When set to the M
the highest speed at all times.
g341398
Press the M
AX
machine to M
AX
13
(Figure
(Figure 12).
Figure 12
, the blade speed is
UNSMART
, the blade speed remains at
AX
button below the On button to set the
speed (Figure 12).
12).
g342174
UNSMART