Bagging The Clippings; Installing The Grass Box - Toro Flex-Force Power System 60V MAX 36 cm Bedienungsanleitung

Bagging the Clippings

Use the grass box when you want to collect grass and leaf clippings from the lawn.
If the mulch plug is on the machine, remove it before bagging the clippings. Refer to
(page 14).

Installing the Grass Box

1. Move the handle into the upright position and lift up the rear deflector (A of
2. Install the hooks of the grass box into the notches on the rear of the machine (B of
3. Allow the rear deflector to rest on the box (C of
4. Return the handle back to the operating position; refer to
Grass Box Full Indicator
The grass box is fitted with a full indicator at the rear of the hard top. While grass is being collected, air flows
through the grass box, raising the indicator flap into the open position. When the grass box is full, the airflow is
blocked, and the indicator flap closes.
Figure 14).
Folding the Handle (page
Figure 14
Figure 15
15
Removing the Mulch Plug
Figure 14).
Figure 14).
19).
g341400
g363501