Maintenance; Lubricating The Machine; Replacing The Blade - Toro Flex-Force Power System 60V MAX 36 cm Bedienungsanleitung

Maintenance

Remove the safety key and battery pack from the
machine before maintaining or cleaning the machine.
Use only the manufacturer's recommended
replacement parts and accessories.
Inspect and maintain the machine regularly. Have
the machine repaired only by an Authorized Service
Dealer.

Lubricating the Machine

You do not need to lubricate the machine; all the
bearings have been lubricated at the factory for the
life of the machine.

Replacing the Blade

Service Interval: Yearly
Important:
You will need a torque wrench to
install the blade properly. If you do not have a
torque wrench or are uncomfortable performing
this procedure, contact an Authorized Service
Dealer.
If the blade is damaged or cracked, replace it
immediately. If the blade edge is dull or nicked, have
it sharpened and balanced, or replace it.
WARNING
When servicing the blade, be aware that the
blade can still move even though the power
source is off. The blade is sharp; contacting
the blade can result in serious personal injury.
Wear gloves when servicing the blade.
1. Remove the safety key and battery pack from
the machine.
2. Use a block of wood to hold the blade steady
(Figure 24).
3. Remove the blade bolt, washer, and blade; save
the washer and blade bolt
4. Install the new blade, washer, and blade bolt
(Figure 25).
Important:
Position the curved ends of the
blade facing up toward the machine housing.
5. Use a torque wrench to tighten the blade bolt
to 35 N∙m (26 ft-lb).
(Figure 24).
21
Figure 24
Figure 25
g357349
g357350