Technical Specifications; Riser Lengths; T Ake-Off , Flight And Fl Ying Techniques; Pre-Flight Checks - SKY PARAGLIDERS AYA 2 XS Bedienungsanleitung

3.3. Technical Specifications
AYA 2
Layout surface (m )
2
Layout span (m)
Layout aspect ratio
Projected surface (m )
2
Projected span (m)
Projected aspect ratio
Number of cells
Weight of the glider (kg)
Take-off weight range (kg)
Maximum symmetric control travel at
maximum weight in flight (cm)
Number of risers
Certification EN/LTF
3.4. Riser lengths
Adjustable, removable or variable device: none.
The risers have no trimmers.
XS S M
21.60 23.36 25.27
10.06 10.46 10.88
4.69 4.69 4.69
19.11 20.68 22.36
8.34 8.67 9.02
3.64 3.64 3.64
37 37 37
4 4.25 4.55
50-72 60-80 75-95
see the certification protocols
3+1
A
Basic setting
A1
A2
B
C
Acelerated
A1
A2
B
C
Lenght of the speed system
User manual / Handbuch / Návod k obsluze
L XL
27.33 29.56
11.32 11.77
4.69 4.69
24.19 26.16
9.38 9.75
3.64 3.64
37 37
4.8 5.1
90 -110 105-130
XS,S M, L, XL
47 cm 50 cm
47 cm 50 cm
47 cm 50 cm
47 cm 50 cm
XS,S M, L, XL
36.5 cm 39 cm
38.9 cm 41.5 cm
40.3 cm 43 cm
47 cm 50 cm
10.5 cm 11 cm
Tolerance: +/- 5 mm
AYA 2
4. T AKE-OFF , FLIGHT
AND FL YING
TECHNIQUES
In general, the AYA 2 will behave conventionally to most
paragliders. However, listed below are several points which will
enable you to familiarise yourself with your new glider more
rapidly.
4.1. Pre-flight Checks
• Check the sail for damage to both surfaces, the internal
structure (ribs, diagonals) and seams.
• Check that the lines are not damaged or tangled.
• Check that the quick-links which connect the lines to the
risers are undamaged and correctly tightened.
• Check that the risers are not damaged or twisted.
• Lastly, check that the brake handles are correctly attached
and that each line runs freely through its pulley.

4.2. Take-off

Lay the paraglider out with the leading edge in a horseshoe
shape. Hold the A risers close to the quick links and move
forward until the lines get stretched. You should now be perfectly
centered with your wing. With no wind or light headwind, with
lines stretched, AYA 2 inflates rapidly and rises over your head
with some dynamic steps.
We recommend that you do not pull the risers too far forward or
down, which could cause a collapse of the leading edge, but
simply follow them until your glider reaches its angle of flight. It
is important that the gravity centre of your body stays in front of
your feet during the rise of the glider to constantly load the risers.
A controlled inflation allows you to check the wings and lines
during the last phase as it comes up and thus avoids the need
to use brakes. Depending on the wind conditions or the slope,
an adequate use of brakes can help you to take-off more quickly
.
8