Safety Instructions - FLUX F 550 Originalbetriebsanleitung

1.4 Safety instructions

All safety instructions (including those in the attachments) must be observed and followed.
Failure to follow the safety instructions may lead to serious injury or death or cause
environmental and/or property damage.
Adherence to the safety instructions contained in these operating instructions will help you
to avoid risks, to operate the pump efficiently and to ensure that the product is used to its
full potential.
Safety instructions on the activities are listed at the start of the respective chapter and the
attachments.
Special safety instructions on individual action steps are given under the respective action
step.
Attention!
Make sure that the operator has read and understood the operating instruc-
tions.
Check the motor, mains plug, pump and hose regularly for operating safety.
Danger from splashing liquids!
•
•
•
•
•
•
•
•
•
Attention!
If the eccentric worm-drive pump is operated against a closed outlet, a by-pass
(pressure relief) valve must be used.
The maximum operating pressure and the operating temperature must not
be exceeded.
High operating pressure may result in the containers or the hoses bursting
or becoming loose. Make sure that excessive pressure does not result when
filling a container.
Keep the air escaping and the displacement in mind when immersing the
pump in the liquid. Lower the pump carefully.
Fill carefully and at an appropriate speed to avoid leakage of the liquid.
After the filling, allow the excess to drip off the quick action tap. There may
be liquid left in the outlet tube, which will then leak out.
Install appropriate splash guards for open barrels or containers.
Empty the pump, hose and fittings prior to removing the motor.
In case of counter-pressure, do not remove the motor or use a pump with an
inner tube lock.
Remove spilled liquid from the floor and dispose of it in an environmentally
sound manner.
Original Manual High Viscosity Liquid Pumps Type F 550
and Sanitary Pumps Type F 560 25 / 84