VOLTCRAFT TK-1000 Bedienungsanleitung Seite 37

11 Stand bracket
12 "▼/25%" button
13 "►/100%" button
14 "°C/°F" / "SET0%"
button
15 "Ramp/Step" /
"SET100%" button
16 "TC/SETUP" button
17 Battery compartment
Rear hinged stand bracket for better display reading.
Briefly pressing the button (<1.5 s) decreases the
current numeric value of the selected decimal place
by 1 point.
Pressing and holding the button (>1.5 s) decreases
the numeric value by 25% of the entire current range
(voltage/resistance/temperature).
Briefly pressing the button (<1.5 s) moves the
selected decimal place to the right.
Pressing and holding the button (>1.5 s) increases
the numeric value to 100% of the entire current range
(voltage/resistance/temperature).
Briefly pressing the button (<1.5 s) changes the
temperature unit in "TC" and "RTD" modes.
Pressing and holding the button (>1.5 s) manually
sets the current numeric value to 0%. This value is
retained even after switching off the device.
Briefly pressing the button (<1.5 s) changes the ramp/
step mode with continuous automatic repetition:
C ontinuous ramp output 0% - 100% - 0% ... with
a slow gradient
C ontinuous ramp output 0% - 100% - 0% ... with
a rapid gradient
C ontinuous step output 0% - 100% - 0% ... in
25% increments
Pressing and holding the button (>1.5 s) manually
sets the current numeric value to 100%. This value is
retained even after switching off the device.
Briefly pressing the button (<1.5 s) switches to ther-
mocouple mode or changes the sensor type.
Pressing and holding the button (>1.5 s) opens the
manual temperature compensation setting and saves
the value.
Battery compartment on the back of the device for a
9 V block battery.
37