Concept Perfect Air ZV2021 Bedienungsanleitung Seite 85

The remote control does
not work.
The display shows an error
code "E0".
The display shows an error
code "E1".
The display shows an error
code "EF".
OPERATING USING THE APP
Before you can control the device through the application, it is necessary to connect it to your phone and give it access
to your Wi-Fi network.
Recommended distance during setting is less than 4 meters.
Make sure that your appliance, router and your mobile phone are close together so that you can pair your phone with
the device with no problems.
Download and installation of the app
1. Scan the QR code below (Fig. 1) or find and download the "Concept Home" application on Google Play or App Store.
2. If you already have Concept Home, open the app, sign in and follow the pairing instructions.
3. If you are a new user, register (Fig. 3-7) and follow the instructions.
ZV2021
The remote control batteries are
dead.
The remote control is out of range
of the appliance.
The plastic film was not removed
from the battery.
The water detector (PCB) and
electronics (PCB) are disconnected.
The water detector (PDB) is
damaged.
The factory setting of the water
detector (PCB) failed.
The water detector (PDB) is
damaged.
There is too much water in the
base.
Replace the batteries.
Step closer to the appliance and repeat the
action.
Remove the protective plastic film.
Contact your dealer.
Contact your dealer.
Follow these steps to reset the device:
1. Switch off the appliance and unplug it
from the mains. 2. Remove the water tank.
3. Dry the silver base stand.
4. Plug the appliance into the socket.
5. Press the POWER button twice, then
press and hold the POWER button again for
2 seconds. "PL" and then "PA" appears on
the display.
6. Unplug the appliance from the mains.
The appliance has been reset. The entire
process of resetting the appliance must
be completed within one minute. If the
appliance no longer works, contact your
dealer.
Contact your dealer.
Switch off the humidifier and unplug it.
Remove the water tank and pour the water
out of the base. Check the water tank for
leaks. If there is no leak, return the water
tank to the appliance.
EN
85