Concept Perfect Air ZV2021 Bedienungsanleitung Seite 84

EN
White dust is formed on
the furniture.
Water accumulates
outside the humidifier or
the surrounding area.
The mist has an unusual
odour.
The device generates
unusual noise
The appliance has stopped
producing steam.
The display shows
incorrect humidity level.
Control panel does not
work.
Steam is coming out
outside of the steam
outlet.
The hot steam function
does not work.
84
Hard water can deposit a certain
amount of white powder on the
ultrasonic disk. The white powder
is decomposed by ultrasonic
vibrations and blows into the air
along with the mist. White powder
in the air settles on the furniture.
Saturation of moisture.
The device is not levelled and
accumulates water.
The appliance is new.
Water in the water tank is dirty or it
has been there for too long.
The noise in the water tank is
caused by a low water content.
The appliance is not placed on
a flat surface.
The air humidity is sufficient.
The timer symbol is lit on the
display.
The set timer is over.
The room is too large.
Steam has gotten into the sensor.
Wet hands.
Control panel malfunction
The water tank is incorrectly
inserted.
The humidifier is not heated up yet.
The steam is too fine.
The room is too cold and the steam
cools quickly.
If the problem persists, use distilled water.
Do not forget to clean the ultrasonic disk
and the filter after a short use.
Switch off the humidifier or set it to a low
mist level.
Unplug it and place it on a flat surface. Aim
the mist nozzle away from objects. Place it
on a waterproof, flat surface at least 60 cm
from the floor.
Open the water tank and leave it in a dark
and cool place for 12 hours.
Clean the water tank and pour fresh,
distilled or demineralized water into it.
Fill the water tank.
Move the appliance to a stable, flat surface.
Refill the water tank.
Switch on the humidifier.
Move the humidifier to a smaller room.
Switch off the humidifier and leave it in
a dry place to dry properly before using
it again. If the sensor is still not working,
contact an authorized service centre.
Keep your hand dry. Do not handle the
appliance with wet hands.
Contact your dealer.
Switch off the appliance and make sure that
it is not plugged in. Open the lid and insert
the water tank correctly.
Wait a few minutes for the appliance to heat
up to the correct temperature.
Increase the steam release level.
Increase the steam release level and the
room temperature.
ZV2021