Cleaning And Maintenance - HEYLO IR 20 H Betriebsanleitung

Infrared oil heater IR 20 H (battery)
Malfunction / Possible cause / remedy
message
Fuse blown
Contact HEYLO Customer Service.
The mo- No fuel
tor/pump
– Set the device switch to OFF.
starts, but
– Top up fuel tank.
there is no
– Switch on the device - set the
ignition or
device switch to position ON.
flame
Ignitor dirty
Contact HEYLO Customer Service.
Fuel contaminated
Clean the filter (see Checking and
cleaning the device
Nozzle blocked
Contact HEYLO Customer Service.
Photocell dirty, defective or incor-
rectly installed
Contact HEYLO Customer Service.
Foreign objects in tank
– Set the device switch to OFF.
– Empty the tank and fill it with
clean fuel (see Checking and
cleaning the device
– Clean the filter (see Checking and
cleaning the device
Electrodes spent or installed at
wrong distance to each other
Contact HEYLO Customer Service.
Rotor blocked Motor defective
or rotating too
Contact HEYLO Customer Service.
slowly
Table 8: Malfunction table
18 Cleaning and
maintenance
For cleaning and maintenance, observe the follow-
ing general safety rules:
– All work must be carried out by trained and au-
thorised technicians.
a) Switch off the device before starting work, wait
until the cooling phase has elapsed and then
remove the battery or disconnect the mains
plug.
b) Wear suitable personal protective equipment.
c) Before restarting the device, install all safety
devices as attached at the factory.
36 / 42
[ 37]).
[ 37]).
[ 37]).
d) Check that the safety devices are working
properly.
e) After completion of the work, remove all tools
and objects from the working area around the
device.
f) Use only original spare parts and accessories.
DANGER
Danger to life from electric shock
Touching live parts can be fatal.
a) Before carrying out any work on electrical com-
ponents, let the device cool down, if necessary,
and remove the battery (battery operation) or
disconnect the mains plug (mains power opera-
tion).
CAUTION
Risk of injury from burns on hot surfaces
The housing of the device and in particular the heat-
ing plate, the protective grille, the combustion
chamber and the guard become very hot during
operation, and can cause burns. Particular caution
is required at places where children or persons with
a physical, sensory or mental disability are present.
a) Do not touch hot surfaces.
b) Wear protective gloves.
c) If children or persons with a physical, sensory
or mental disability are present near the device,
supervise them closely.
CAUTION
Risk of injury from inadvertent device start-
up
Uncontrolled start-up of the burner can lead to inju-
ry.
a) Switch the device off at the device switch and
remove the battery or disconnect the mains
plug.
CAUTION
Risk of injury due to missing guards
Missing guards can lead to injury.
a) Before switching on the device, install all
guards that may have been removed for trou-
bleshooting.
b) Check all the safety devices before switching
on the device.
EN