Maintenance And Troubleshooting; Notes On Fire Protection - HEYLO IR 20 H Betriebsanleitung

– The device must be kept in proper working or-
der. Before using the device, its condition must
be checked.
– All relevant statutory accident prevention regula-
tions and other applicable safety rules must be
strictly adhered to.
– Keep the device away from children. Take suita-
ble measures to ensure that children cannot ac-
cess the device while it is in operation.
– Certain components of the device can become
very hot, causing burns. Special safety
measures are required when the device is oper-
ated in areas where there are children or other
vulnerable persons.
Safety instructions for work on electrical
equipment
The following rules apply to all work on the electrical
equipment of the device:
– There is a risk of fatal injury from incorrect instal-
lation of the electrical system or from a failure of
the insulation during operation.
– All work on the electrical equipment must be car-
ried out by a qualified electrician. Always keep
switch cabinets closed.
– For mains power operation, the device must be
earthed. The mains socket to which the device is
connected must be equipped with a RC circuit
breaker.
– When the device is connected to the power
mains and the device switch is off, the device
remains powered.
– After work on the device, test the safety devices
to make sure they work properly.
– Unauthorized modifications to the device are
prohibited.
Instructions for transport and installation
The following general rules apply to the transport
and installation of the device:
– Before lifting or moving the device, switch it off,
remove the battery or disconnect the mains plug
and allow the device to cool down.
– Always lift and move the device by its handle.
Safety instructions for device operation
The following general rules apply to the operation of
the device:
– The device must only be operated by persons
who have been properly instructed in its opera-
tion.
– Do not cover the device during operation.
– Never modify, bypass, remove or otherwise dis-
able safety devices. Regularly check and test the
safety devices.
EN
Infrared oil heater IR 20 H (battery)
– When operated unattended, the device must be
controlled by a room thermostat (optional
equipment).
– All guards, covers and hoods must be correctly
installed.
– It is forbidden to make any modifications to de-
vice.
– Do not operate the device, if its battery or the
power cord is damaged.
– Never disconnect the device plug by pulling the
power cord.
Do not touch the mains plug with wet or moist
hands.
– After running the heater for the first time, the
heating plate changes colour. This is normal.

Maintenance and troubleshooting

The following general rules apply to all maintenance
and troubleshooting work:
– Maintenance and troubleshooting tasks must be
performed by suitably qualified persons only.
– Before commencing work, allow the device to
cool down.
– Switch off the device and remove the battery or
disconnect the mains plug.
13.1

Notes on fire protection

The device generates heats from burning fuel. Due
to the ignition source (burner) and the high tempera-
tures, increased precautions must be taken to mini-
mise the risk of fire.
– WARNING! Never cover the device, as it
might otherwise overheat.
– Keep the air inlet to the burner unobstructed and
free of dirt. Reduced air flow can lead to over-
heating of the device. Do not operate the device
near curtains or other objects that might come
into contact with it or might block its air inlet.
– Do not operate the device near open fires or
other heat sources.
– Do not operate the device near flammable ob-
jects.
– Do not operate or store the device in aggressive
atmospheres, or areas where there might be
combustible gases, gas-air or dust-air mixtures.
– Do not operate or store the device in areas
where combustible fumes of gasoline, solvents
or thinners are present.
– Portable fuel tanks must be installed and operat-
ed in accordance with the technical rules for the
storage of liquid and solid hazardous substances
in stationary containers and filling and emptying
installations for non-stationary containers (TRGS
509).
25 / 42