OHAUS Defender 3000 i-DT33P Bedienungsanleitung Seite 9

Defender 3000 Indicators
1. Remove the battery cover in the direction of
the arrow.
3. Slightly push the end of the charging cover
(circled) in the direction of the arrow and take
it out.
5. Remove the five screws (circled) from the
rear housing.
7. Close the rear housing, retighten the screws and re-install the lead-acid battery after finishing internal
connections
Note: The screws should be tightened to 1 N•m (8-9 in-lb) torque.
2. Take out the lead-acid battery (circled).
4. Remove the two screws on the charging board
(circled) and take it out.
6. Open the rear housing.
EN-7