ATH-Heinl Cross Lift 35 OG Bedienungsanleitung Seite 85

Pneumatic connection
a. Fit the pneumatic hose or hoses as shown below.
P1 = Slave scissors main lift
A2 = Slave cylinder wheel-free lift
AV2 = Unlocking main lift
When routing the hydraulic hoses, make sure that the hose is clear of any
moving part. Make sure to keep the hoses and fittings clean from dust.
Failure to do so may result in hydraulic line failure which may result in
damage or personal harm.
The corresponding circuit diagram can be found in Appendix 6.1 of these operating instructions.
® Copyright ATH-Heinl GmbH & Co. KG, All rights reserved / Misprints and technical changes reserved / As of: 2021-11
P2 = Main scissors main lift
AV1 = Unlocking wheel-free lift
AV3 = Lowering speed control valve
Manufacturer ATH-Heinl GmbH & CO.KG
- 24 -