BenQ LU9255 Installationsanleitung Seite 9

8
OVERSCAN
Press to select overscan mode.
FREEZE
Freezes the projected image.
LAMP MODE
Press to display OSD menu to select desired light mode.
3D MODE
Press to display 3D setup menu.
INFO.
Press to display INFORMATION menu.
LIGHT
Press to open backlight of remote controller.
CLEAR
Clear remote ID SET assigned to all projectors.
Press CLEAR and ID SET for five seconds. The LED blinks three times
then the ID setting is cleared.
SHUTTER
The function is not available on this projector.
ID SET
• Remote control ID SET (set the particular remote code)
Press to set remote ID.
Press ID SET for three seconds. The POWER indicator on the remote
control blinks, then press 01~99 to designate an ID.
Note:
The remote control number (Remote control ID) must match the Pro-
jector ID Setting number for accurate control.
• Clear Remote ID SET (set remote code to all)
Press CLEAR and ID SET for five seconds. The POWER
indicator on the remote control blinks a single instance to reset
remote code to all,
can control projector no matter projector id
setting.
Numeric buttons
Enters numbers in network settings.
Numeric buttons 1, 2, 3, 4 cannot be pressed when asked to enter pass-
word.
WIRE REMOTE jack
Connect to projector for wire remote control.