Intended Use - ESX POWER4 Bedienungsanleitung

INTENDED USE

• This product is only designed for the use in a vehicle with 12 volt on-board voltage with negative ground
and functions as an amplifier for audio signals. In principle, this product should be used for installation in
subwoofer enclosures.
• Please use the product only in its intended manner. Any other use may lead to damage to the product or
in the vicinity of the product.
DISPOSAL
If you have to dispose of the device, please note that no electronic devices may be disposed of with
household waste. Dispose of the device in a suitable recycling facility in accordance with local waste
regulations. If necessary, consult your local authority or your dealer.
INSTALLATION
• You will find a cutout template in the scope of delivery, which you can use to mark the amplifier opening
in the housing.
• Then connect the subwoofer to the amplifier module. Make sure that the polarity is correct. Refer to the
next page for the minimum load impedance of the subwoofer (s).
• Then use the six enclosed screws to attach the amplifier module to the enclosure.
18
CLIP PRO PWR
PHASE
CLASS D AMPLIFIER
AUTO
SHIFT
TURN-ON
180°
LOW PASS
120 Hz
0°
40 Hz
INPUT
SUBSONIC
VOLTAGE
35 Hz
40 V
5 Hz
15 V
LEVEL
MAX
EPS
LOAD
MIN
10 R
150 R
REMOTE
600 R
HIGH LEVEL
INPUT
MAX
L
MIN
R
BASS BOOST
LINE INPUT
L R
AUDIO DESIGN GMBH · AM BREILINGSWEG 3 · D-76709 KRONAU
SIGNAL
DC
REM
25 A
FUSES
25 A
+12V
REM
GND