HMS LOOP13 Bedienungsanleitung Seite 27

E1 communication defect
E2 Motor defect
E5 Overloading protect
E6 Explosion-proof rushed
No heart rate display
E9 Ochrona złożenia
Incompleted information show
on console
Treadmill didn't work
The running belt does not run
smoothly
Running belt slips
The keys malfunction
Stop abruptly under normal
state
1. Connect wire loose or defect
2. Console defect
3. Controller defect
1. Motor connect wire or motor
defect
1. The friction of running belt is too
big
2. Controller defect
3. Motor defect
1. Controller defect
1. The communication wire is not
connect well or defect
2. Main board defect
3. When treadmill fold
1. Controller defect
2. Sensor or magnet defect
1. The screw off console loose
2. Console defect
1. no power
2. safety key isn't in the right position
3. broken circuit signal system
4. switch off
5. fuse burnt out
1. no enough lubrication
2. running belt too tight
1. running belt too loose
2. motor belt too loose
1. broken keys
1. Safety key drop out
2. broken system
1. Well connect the wire or change
the wire
2. Change console
3. Change controller
1. Change motor connect wire or
motor defect
1. Add silicone oil
2. Change controller
3. Change motor
1. Change controller
1. Connect the wire well or change
the wire
2. Change the console
3. Turn off power, lay flat the
running deck, turn on the power
1. Change controller
2. Change sensor or magnet defect
1. Fasten the screw
2. Change the console
1. Plug into socket
2. Replace the safety key
3. Check the controller input and
signal wire
4. Place the power switch in the
"NO"position.
5. Change the fuse
1. Use the Silicone oil
2. Adjust the tightness of running
belt
1. Adjust the tightness of running
belt
2. Adjust the tightness of motor belt
a. Change the key board and wire
b. Change the mainboard
c. Change the console
1. Replace the safety key
2. Ask serviceman to repair it