Makita DVC860L Betriebsanleitung Seite 8

Applicable battery cartridge and charger
Battery cartridge
Charger
• Some of the battery cartridges and chargers listed above may not be available depending on your region of residence.
WARNING:
• Only use the battery cartridges and chargers listed above. Use of any other battery cartridges and chargers may
cause injury and/or fire.
Symbols
The followings show the symbols which may be used for
the equipment. Be sure that you understand their
meaning before use.
..... Read instruction manual.
................... Take particular care and attention.
.................. Warning! The cleaner may contain
hazardous dust.
................... Never stand on the cleaner.
.................... Dust class L (light). The cleaners are
capable of picking up dust class L.
Follow your country's regulations
relating to dusts and to occupational
health and safety.
.................. DOUBLE INSULATION
Ni-MH
............ Only for EU countries
Li-ion
Due to the presence of hazardous
components in the equipment, waste
electrical and electronic equipment,
accumulators and batteries may have a
negative impact on the environment
and human health.
Do not dispose of electrical and
electronic appliances or batteries with
household waste!
In accordance with the European
Directive on waste electrical and
electronic equipment and on
accumulators and batteries and waste
accumulators and batteries, as well as
their adaptation to national law, waste
electrical equipment, batteries and
accumulators should be stored
separately and delivered to a separate
collection point for municipal waste,
operating in accordance with the
regulations on environmental
protection.
This is indicated by the symbol of the
crossed-out wheeled bin placed on the
equipment.
8
BL1815N/BL1820B/BL1830B/BL1840B/BL1850B/BL1860B
DC18RC/DC18RD/DC18RE/DC18SD/DC18SE/DC18SF/DC18SH
Intended use
END118-1
The tool is suitable for commercial use, for example in
hotels, schools, hospitals, factories, shops, offices and
rental businesses.
DVC860L
The tool is intended for collecting both wet and dry dust.
DVC861L
The tool is intended for collecting dry dust only.
Power supply
The tool should be connected only to a power supply of
the same voltage as indicated on the nameplate, and can
only be operated on single-phase AC supply. They are
double-insulated and can, therefore, also be used from
sockets without earth wire.
Corded and cordless vacuum
cleaner safety warnings
WARNING: IMPORTANT! READ CAREFULLY all
safety warnings and all instructions BEFORE USE.
Failure to follow the warnings and instructions may result
in electric shock, fire and/or serious injury.
1. Before use, make sure that this cleaner must be
used by people who have been adequately
instructed on the use of this cleaner.
2. Before use, operators shall be provided with
information, instruction and training for the use of
the machine and the substances for which it is to
be used, including the safe method of removal and
disposal of the material collected.
3. If foam/liquid comes out, switch off immediately.
4. Clean the water level limiting device regularly and
examine it for signs of damage.
5. Do not use the cleaner without the filter. Replace a
damaged filter immediately.
6. USE OF EXTENSION CORD. When using an
extension cord because of the great distance to
your power source, try to employ a cord that is
sufficiently thick but not too long, or cleaner
performance will be adversely affected. For
outdoor applications use an extension cord
suitable for outdoor use.
7. VOLTAGE WARNING: Before connecting the
cleaner to a power source (receptacle, outlet, etc.)
be sure the voltage supplied is the same as that
specified on the nameplate of the cleaner. A power
source with voltage greater than that specified for
the cleaner can result in SERIOUS INJURY to the
operator as well as damage to the cleaner. If in
doubt, DO NOT PLUG IN THE CLEANER. Using a
power source with voltage less than the
nameplate rating is harmful to the motor.
ENE084-1
ENF002-2
ENB124-5