NEO TOOLS 90-093 Anleitung Seite 11

USING INSTRUCTIONS
Control panel/Remote control
1. Setting Button
2. Up Button
3. Down Button
4. Power Button
5. Heating Element Working Indicator
6. Low Heating Indicator
7. High heating Indicator
Starting
− Take out the heater from the carton carefully. Please save the carton for off-season storage.
− Make sure the power switch is in the OFF position before plugging it in.
− Ensure the heater is fulyy assembled according to the Mounting Guide.
− It's better not to use the same electric outlet with other high wattage electrical appliances in order to avoid overloading you circuit.
Turn ON
Plug in and turn on power switch, heater is in stand-by with buttons 1/2/3/4 on. Press button 4, heater turns on, display shows current area
temperature.
Plug in the unit and turn on its power switch, it is in standby mode and shows current time, with button light 1/2/3/4. on. But then button light 1/2/3
will disappear after 10s.
Temp. Setting
Press button 1, temp. indicator flashes and its setting is activated. By pressing buttons 2 and 3, we select desired temp. and save it. Heater is
heating, display shows current temperature and button 5 lights on.
Press button 1, temp indicator flashes and its setting is activated. Press 2 or 3 to set the temperature and 1 to save it, or just leave it 5s, setting
is saved automatically.
Press 2/3 on the remoter for required temp and save the setting by OK.
Setting Timer
Timer Start Heating Time
8. Timer Indicator
9. Temperature Indicator
10. LED Number Display
11. ECO function
12. Low/High Heating Selection
13. WiFi indicator (If connected OK, wifi indicator lights on; if failed)