Error Messages/Troubleshooting; Cleaning And Storing The Unit; Technical Specifications - Beurer medical BM 48 Gebrauchsanweisung

average value of the morning measurements for the last 7
days will be displayed. (morning: 5 a.m. – 9 a.m., display
). If you press the memory button M again, the average
value of the evening measurements for the last 7 days will
be displayed. (evening: 6 p.m. – 8 p.m., display
continue to press the memory button M, the most recent
individual measured values are displayed in turn with the
date and time.
• The measured values in the corresponding user memory
can be deleted by switching on the device, selecting the
desired user memory, pressing the memory button M and
then pressing function buttons and
5 seconds.
• The device automatically switches to standby mode (date
and time displayed).

8. Error messages/troubleshooting

In the event of errors, the error message
display.
Error messages may appear if:
• It was not possible to record the pulse: E1 ;
• You move or speak during the measurement: E2 ;
• The cuff is fastened too tightly or loosely: E3 ;
• Errors occur during the measurement: E4 ;
All manuals and user guides at all-guides.com
• The pump pressure is higher than 300 mmHg: E5 ;
• The batteries are almost empty
In such cases, repeat the measurement. Ensure that you do
not move or speak.
). If you
If necessary, reinsert or replace the batteries.

9. Cleaning and storing the unit

• Clean your blood pressure monitor carefully using a slightly
• Do not use any cleaning agents or solvents.
simultaneously for
• Under no circumstances should you hold the unit under
• If you store the unit, no heavy objects should be placed on

10. Technical specifications

_ appears on the
Model no.
Measurement
method
35
damp cloth only.
water, as this can cause liquid to enter and damage the unit.
top of it. Remove the batteries. The cuff line should not be
bent sharply.
BM 48
Oscillometric, non-invasive blood
pressure measurement on the up-
per arm
: E6 .